Resetter canon mp237. Tektronix repair, service, owner manuals & schematics. 2440 service manual (SN B014064 & below) 070-6603-00. 2710 Operator Manual 2710 Service Manual 2711 2712. Qservice electronics, suppliers for test equipment spare parts and manuals, our inventory contains original service manuals, reprinted and downloadable pdf manuals, new and used electronic test equipment, electronic service and repair parts, for tektronix, hp, and sony consumer electronics. Download TEKTRONIX TM5003 THREE-COMPARTMENT POWER MODULE 1981 SM service manual & repair info for electronics experts. TEKTRONIX 2711 2712 SM. Tektronix Manual: Tektronix 2712 GPIB. Manuals: Tektronix. Tektronix Manual: 2213 service -texts. Eye 287 favorite 1 comment 0.
Tektronix 2712 | |
---|---|
Tektronix 2712 Produced from 1991 to (?) Manuals |
The Tektronix 2712 is a spectrum analyzer with a frequency range of 9 kHz to 1.8 GHz. The minimum resolution bandwidth is 3 kHz, and provides measurement resolution proportional to the frequency accuracy or span. With non-volatile memory (NVRAM) at 124 kB can save up to 108 displays of waveforms and markers, and up to 36 front panel setups, large user-defined key programs, and antenna factor tables.
The single and delta markers provide direct readout of frequency and amplitude information of any point along any displayed trace. Or, get the relative (delta) frequency and amplitude information between any two points along any displayed trace or between traces.
True analog display capability, along with fast sweep speeds and TV Line and TV Field triggering provide demodulation of video carriers for making depth-of-modulation checks or looking at special baseband data, VITS, and other signals. An internal audio amplifier and AM/FM detectors let one hear demodulated signals, using either the build-in speaker or headphone jack for signal identification and troubleshooting and in communications applications.
Additional features include Digital Storage Display (selectable acquisition modes of positive peak only, positive/negative peak, Max hold, Waterfall, and an analog sweep when digital storage is off), Ensemble Averaging, Internal Preamp, Internal Calibrator (accessed through Input Menu), Alternate Reference Level Units (dBm, dBmV, dBV, dBµV, dBµW, and dBµV/m), User-Definable Power-on Status, Center Measure, Graticule Illumination (for CRT photography), and Direct Plot/Print (Printers via Opt. 03 GPIB, or RS-232-C interface via Opt. 08).
Dec 03, 2019 Here is the Latest version Inpage 2009 free download direct link for pc. When software used to grow in office and other institutions, its Developer continued to introduce a new version for it, with advance level Features. In 2009, many people started working with this In page software, which led to increase their popularity. 2009 Inpage have many Features for creating Beautiful layout Urdu. Dec 12, 2019 The free download manager will appear after downloading it and only download it to install the software downloads on the Urdu page. Urdu inpage professional is reliable software for Urdu. It is the full version of the Urdu software. Inpage setup download. Inpage urdu software, free download - InPage, Urdu Word Processor, Urdu Editor, and many more programs. Mar 04, 2019 Inpage free download is available for all windows operating system and it works in both 32-Bit & 64-Bit windows. Also Check out:-Inpage 2009 Free Download For PC MS Office 2016 Professional Free Download. Inpage Free Download Overview. Inpage 2012 free download is a free tool which was released earlier in 1994.
Front panel inputs/outputs are: RF INPUT N connector (50Ω, +20 dBm Max, 100 V DC blocking capacitor); and GEN N connector (50Ω, 0 to -48 dBm, Opt. 4 Tracking Generator generates a sweep frequency to enable the Spectrum Analyzer to make circuit response measurements, i.e. scalar network analysis).
Rear panel inputs/outputs are: J101 SMA connector (Female SMA installed for Opt. 15), J102 EXT TRIG BNC connector (10 kΩ, 50V (DC + peak AC)), J103 DB9 connector (Not RS-232 compatible. Accessory connector: Pin 1 Video Input, Pin 2 Ground, Pin 3 Video Output, Pin 6 Sweep Gate, Pin 7 Sweep Output, all others unused), J104 GPIB connector (IEEE Std 488 connector) or Opt. 08: RS-232 interface (Digital Communication Port.).
Specifications
Frequency Range | 9 kHz to 1.8 GHz |
---|---|
Frequency Span Range (plus 0 Hz and MAX: 180 MHz/div) | 1 kHz/div to 100 MHz/div in 1, 2, 5 sequence |
Resolution Bandwidth Range | -6 dB bandwidth selections are 3 kHz, 30 kHz, 300 kHz, and 5 MHz ; Down to 300 Hz with Opt. 01 |
RF Input impedance | 50 Ω |
Maximum Safe Input Power | +20 dBm (0.1 W or 2.2 V) continuous peak, ≤100 V DC blocking capacitor |
RF Attenuator Range | 0 dB to 50 dB, 2 dB steps |
Sensitivity | -117 dBm at 3 kHz RBW, -129 dBm at 3 kHz RBW w/preamp |
Reference Level Range | -70 dBm to +20 dBm; -23 dBmV to +66.9 dBmV |
Sweep Speed Range | 2 sec/Div to 1 µs/Div in 1, 2, 5 sequence |
Triggering Modes | Free Run, Internal, External, Line, TV Line, and TV Field |
Displayed Average Noise | −66 dBm to −100 dBm |
Display Dynamic Range | 80 dB |
Dynamic Range | ≥100 dBm |
Internal Calibrator | 100 MHz marker at -30 dBm |
Included Accessories | Operator’s Manual; Power Cord; Front Cover; Adapter 50 Ω N Male to BNC Female, 75 Ω to 50 Ω Minimum Loss Attenuator N Male to BNC Female |
Weight | Standard accessories: 11.25 kg (<25 lbs); Basic configuration: 10.2 kg (22.5 lbs) |
Power | 90 − 132 VAC, 48 to 440 Hz; 90 – 250 VAC, 47 to 63 Hz. At 115 VAC, 60 Hz, 90 W (standard), 105 W max (with options) |
Operating Atmospherics | Temperatures: 0 °C to +50 °C; Humidity: MIL-T-28800E; Altitude: Up to 4.6 km (15,000 ft) |
Tek 2712 Service Manual Free
Options
- Opt. 01: 300 Hz Resolution Bandwidth filter; Phase-lock with span/div ≤20 kHz
- Opt. 02: Frequency Counter, 1 Hz or 1 kHz, menu selectable
- Opt. 03: GPIB Interface (cannot be combined with Opt. 09)
- Opt. 04: TG Tracking Generator, 100 kHz to 1.8 GHz (cannot be combined with Opt. 12 or 14)
- Opt. 06: Battery Power Option (2704 Inverter and 2705 Battery Pack)
- Opt. 08: Replace GPIB with RS-232-C (cannot be combined with Opt. 03)
- Opt. 09: Centronix interface (cannot be combined with Opt. 03)
- Opt. 10: Video Monitor mode
- Opt. 11: Non-volatile RAM storage for setups, displays, and user-definable key sequences
- Opt. 12: Quasi-peak detector and additional RBW filters (cannot be combined with Opt. 04 or 14)
- Opt. 14: Adds Resolution Bandwidths of 1 kHz, 10 kHz, 100 kHz, and 1 MHz (cannot be combined with Opt. 04 or 12)
- Opt. 15: Tek 1405 TV Sideband Adapter interface installed at J101 as SMA female
- Opt. 20: EMC antenna set plus tripod and coax suitable for tests to 1 GHz
- Opt. 30: Rackmount
- Opt. 33: Travel Line Package
- Opt. 34: Portable to Rackmount Adapter.
See also the 2706 preselector and 2707 tracking generator.
Pictures
Tek 2712 Service Manual Free
- 2712 with 2706
Tek 2712 Service Manual Online
Retrieved from 'http://w140.com/tekwiki/index.php?title=2712&oldid=52635'